![]() Or routed ports on the device also must be configured with the same first four most significant bits (4MSB) of the MAC address.įor example, if you set the MAC address of any SVI to, set the MAC address of all other SVIs to start with If this command is configured on a single SVI or router port that requires Layer 3 injected packets, all other SVIs ![]() The interface VLAN MAC address that is assigned by default, can be overridden using the mac-address command. Only Cisco Transceiver Modules are supported. The configuration changes to take effect. The dual active and StackWise Virtual link configuration must be performed manually and the device should be rebooted for All inter-chassis systemĬontrol communication between stack members is carried over the reserved VLAN ID 4094 from the global range. When deploying Cisco StackWise Virtual, ensure that VLAN ID 4094 is not used anywhere on the network. Note that you cannot create SVLs on any of the network modules.Ĥx10G breakout cables are not supported with SVLs. When configuring StackWiseVirtual links (SVLs) on 9500-40X and C9500-16X models of the Cisco Catalyst 9500 Series Switches, ![]() The Federal Information Processing Standards (FIPS) is not supported on Cisco StackWise Virtual links.Ĭisco StackWise Virtual is supported only on the following models:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |